Soil Preparation For a Beautiful Lawn
Follow these simple steps for a beautiful, healthy, and trouble-free lawn:

STEP 1.  Clear the site of all building materials (wood, bricks, cement, etc.) as well as any buried stumps, rocks, stones, or other debris that are larger than 2-3 inches in diameter.

STEP 2.  Rough grade the entire area to eliminate any drainage problems on the entire property.  This would include sloping the grade away from building foundations, eliminating or reducing severe slopes, and filling low-lying areas.  A tractor mounted blade and/or box are most often used for rough grading, but if the area is small, it can be done with hand tools.  The rough grading will probably uncover more debris that should be removed and not buried.

STEP 3.  Initial tilling to a depth of at least 2 inches, should be completed prior to adding any soil amendments.  This will control most annual weeds, alleviate subsoil compaction, permit a bonding of the topsoil to the subsoil, and improve root penetration as well as air exchange and water movement.

STEP 4.  Add topsoil (if needed) to achieve total topsoil depth of 4-6 inches, after firming.  The topsoil should be a loamy sand, sandy loam, clay loam, loam, silt loam, sandy clay loam, or other soil suitable for the area.  To the extent possible, practical, affordable, and available, incorporate humus (fully decomposed organic matter) into the topsoil.

STEP 5.  Test the soil pH with a chemical soil test to determine if any pH correcting materials are required.  Acidic soils (pH of 6 and below) can be improved with the addition of lime.  Alkaline soils (pH of 7.5 and higher) can be improved with the addition of sulfur or gypsum. 

STEP 6.  Apply "starter fertilizer" that is high in phosphate ("P" or the middle number on a bag of fertilizer), at a rate recommended for the particular project.  To avoid root injury to the newly installed turf, the fertilizer should be raked into the top 3-4 inches.

STEP 7.  Finish grade the entire site, maintaining the rough grading contours and slopes, with a tractor-mounted box blade or pulverizer for large areas or a heavy-duty rake for smaller areas.

STEP 8.  Roll the area with a lawn roller one-third full of water to firm and settle the surface.  Low spots revealed by this step should be filled to match the surrounding grade surface.  If time permits, allow the area to settle further with rainfall or by applying irrigation.